SOLDERLESS DIY RGB Kit for Guitar Hero Controllers by RetroCultMods

Current processing time before shipping is:

1-3 Days

This is a kit containing everything you need to convert your official Red Octane Guitar Hero controller into a modded guitar controller with RGB light-up frets that you can use with Clone Hero/YARG/Fortnite Festival on PC, and Guitar Hero/Rock Band on PS3, PS4, and PS5! Also works on Android and modded Xbox 360s!

Want Xbox compatibility? Make sure to grab this as well:

Controller Authentication Upgrade

**NO SOLDERING IS REQUIRED**

Supported models:

SG
Kramer
Xplorer
Wii Les Paul
Xbox/PlayStation Les Paul (slight case modification needed; easy to do)
Wii World Tour*
Xbox/PlayStation World Tour
Wii GH5
Xbox/PlayStation GH5

*It is important to check to see which model of fret you have if you plan to use a Wii World Tour model. Please message me before or shortly after buying and I will help you identify them!

Included in this kit:

5x Translucent 3D Printed Frets (vary depending on chosen model)
1x RetroCultMods ZeroBoard SL with Kailh Box Navy switches preinstalled
1x RetroCultMods RGB Fretboard SL with Kailh Choc Red switches preinstalled
1x Xplorer Breakout board (Xplorer kits only)
2x Tilt sensor
3x JST Wires for Strumboard to Fretboard connection
2-4x Lever actuated wire terminals (quantity depends on model chosen)
6-10x Extension jumper wires (quantity depends on model chosen)
6x Screws (original screws can be used instead)
6x Washers
1x 10 foot USB-C cable

Instructions will be included with your purchase!

The following are required to complete the mod, but are not included in the kit:

Screwdriver with:
-Torx Bits (T9, T10, and T6 specifically, but I recommend getting a whole set of Torx bits if you can!)
-Philips head bits (PH00, PH0, and PH1 work well)
-1/16" flathead bit (for screw terminals on ZeroBoard SL)

Wire stripper with 24-30 AWG shears

Flush cutters (needed for models where case modification is required)

Some tape or other adhesive is recommended but not required

Programming and configuration is not needed for most games on PC, PS3/4/5, or Mac but can be accomplished with the programming tool listed here:

https://retrocultmods.com/updating-to-the-new-santroller-firmware/

If you have any questions, do not hesitate to contact me at Collin@RetroCultMods.com! :)