RetroCultMods
DIY Modding Kit for Guitar Hero Controllers
DIY Modding Kit for Guitar Hero Controllers
Couldn't load pickup availability
!! This kit REQUIRES both soldering equipment and knowledge to install !!
This is a kit containing everything you need to convert your official Red Octane Guitar Hero controller into a modded XInput guitar controller that you can use with Clone Hero/YARG/Fortnite Festival on PC, and Guitar Hero/Rock Band on PS3, PS4, and PS5!
Supported models:
SG
Xplorer*
Kramer
Les Paul**
World Tour
GH5
*If using the Standard Fretboard, Xplorer models other than 95065 require 3D printed frets:
https://www.etsy.com/listing/1494761719/3d-printed-frets-for-xplorer-controller
**Wii models using the Standard Fretboard require 3D printed frets:
https://www.etsy.com/listing/1480582508/3d-printed-frets-for-wii-controllers
Included in this kit:
1x RetroCultMods Zeroboard
5x Kailh Low Profile Choc Red Linear (silent) switches
2x Kailh Box Navy switch
2x SW-520D Tilt Sensor
1x 12 inch 6 pin wire
4x Strumboard spacers (for use with World Tour models only)
1x RetroCultMods Universal Fretboard or RGB Fretboard
5x 3D Printed translucent frets (RGB Fretboard only)
1x 12 inch 3 pin wire (RGB Fretboard only)
5x 90 degree pin headers (Standard Fretboard only)
6x Screws
1x 10ft USB Cable
Programming is accomplished via the RetroCultMods Programming Tool:
https://retrocultmods.com/programming-tool/
IMPORTANT NOTES:
Soldering equipment and experience not included!
Colors may vary for 6 pin wire, washers, and/or screws; functionality not affected.
Third party guitars have not been officially tested, but feel free to give them a go!
Let me know if you have any questions by emailing support@RetroCultMods.com!
:)
Share


